Description
The swept bend is used to create a smooth 92.5 degree change of direction in 40mm solvent weld waste pipe systems. It is a practical fitting for sink, bath, shower, utility and general plumbing installations where pipework needs to turn neatly.
This 40mm solvent weld swept bend is suitable for compatible solvent weld waste systems and is available in Black, Olive Grey and White to match common pipework colours. The swept shape helps create a smoother directional change than a tighter knuckle bend.
40mm Solvent Weld Swept Bend
The swept bend is designed for 40mm waste pipe systems where a smoother 92.5 degree change of direction is required. It is commonly used where pipework needs to route around units, walls, boxing or other plumbing areas.
- 40mm solvent weld 92.5 degree swept bend
- Used to change waste pipe direction by 92.5 degrees
- Swept shape helps create a smoother pipe run
- Suitable for compatible 40mm solvent weld waste pipe systems
- Available in Black, Olive Grey and White
- Creates a permanent joint when fitted with solvent cement
- Useful for sink, bath, shower and utility waste pipe installations
- Trade waste fitting for solvent weld plumbing systems
Using a Swept Bend
Before fitting, check that the pipe and fitting are the correct size, clean and dry. Cut the pipe square, remove burrs, chamfer the pipe end where required and follow the correct solvent weld process for the system being installed.
Once solvent cement is applied and the joint is made, leave the connection to cure according to the solvent cement instructions before testing or putting the waste system into use.
Bend for 40mm Waste Pipe Runs
This swept bend is suitable for 40mm waste pipework where a smoother directional change is preferred. It can help keep pipe runs neat while reducing the sharpness of the turn compared with a compact knuckle bend.
Before ordering, check the pipe size, colour and bend style required for the installation. If a tighter change of direction is needed, a 40mm knuckle bend or conversion bend may be more suitable.
Swept Bend and Solvent Weld Fittings at TWS
For general UK drainage and waste pipe guidance, see Approved Document H: Drainage and waste disposal.
This 40mm swept bend is part of our solvent weld waste pipe and fittings range. You can also browse related waste pipe, couplers, clips, branches, reducers, access plugs and other bend fittings below.
View 40mm solvent weld waste fittings at TWS.
View solvent weld waste pipe and fittings at TWS.
