Description
The 200mm bend 15° single socket is an underground drainage fitting used to make a small controlled change of direction in 200mm pipework. It is suitable for larger foul water and surface water drainage systems where the pipe route needs a slight alignment adjustment.
This 200mm underground drainage bend is designed for compatible PVC-U underground drainage pipework. The 15° angle is useful for minor route corrections, gradual alignment changes and fine-tuning pipe runs during larger domestic, commercial and groundwork drainage installations.
The single socket design provides one socketed connection, with the opposite end designed to connect into a compatible 200mm socket, coupler or underground drainage fitting. This makes it useful when adjusting a pipe route without needing a double socket bend.
200mm Bend for Underground Drainage
The 200mm bend is used where underground drainage pipework needs a small 15° change of direction. It is suitable for larger drainage runs, foul water systems, surface water layouts, yard drainage and commercial site drainage where 200mm pipework is specified.
A 15° bend is often used where only a slight adjustment is needed. It can help installers keep the pipe route tidy, avoid unnecessary sharp turns and maintain a smoother drainage layout.
- 200mm underground drainage bend
- 15° nominal bend angle
- Single socket design for compatible 200mm pipework
- Suitable for foul water and surface water drainage systems
- PVC-U underground drainage fitting
- Orange-brown / terracotta underground drainage colour
- Useful for larger domestic, commercial and groundwork drainage layouts
- Funke KGB DN 200/15° SDR 41 verified reference if supplier confirms exact item
200mm Bend Single Socket Connection
This 200mm bend has one socketed connection for compatible 200mm underground drainage pipework. The other end can be connected into a suitable 200mm socket, coupler or drainage fitting depending on the pipe layout.
Before installation, check the pipe route, fall direction and bend position. The fitting should sit correctly within the trench and should not be forced into poor alignment. If the route does not line up correctly, adjust the pipework or use suitable additional fittings.
Use suitable pipe lubricant on ring seal joints where required. Make sure pipe ends are clean before jointing. If pipework is cut to length, make a clean square cut and chamfer the edge before fitting. This helps protect the seal and makes the joint easier to assemble.
200mm Bend Installation Use
The 200mm bend should be installed as part of a properly planned underground drainage system. It is useful where a 200mm drainage run needs a slight direction change while keeping the system neat and serviceable.
Correct bedding and backfill are important around the bend. The pipework and fitting should be evenly supported so the drainage system remains stable after installation. Poor support can place stress on the socket and may affect long-term performance.
Because this fitting changes pipe direction, the wider drainage layout should include suitable access for future rodding, inspection or maintenance where required. Always follow the site specification, current UK drainage guidance and manufacturer instructions.
Drainage Bend for 200mm Site Work
This 200mm bend is a practical fitting for builders, groundworkers, landscapers and drainage installers working with larger underground drainage systems. It can be used on new installations, pipework extensions, repairs and drainage alterations.
For best results, use compatible 200mm pipe and fittings from the same underground drainage system where possible. This helps keep jointing simple and supports a clean, consistent installation.
This product is not an access fitting. If inspection or rodding access is needed near this change of direction, use a suitable access bend, access pipe, inspection chamber or rodding point as required by the drainage layout.
Compatible 200mm Underground Drainage Products
This 200mm bend is part of the wider TWS 200mm underground drainage range, making it easy to match with compatible pipe, couplers, slip couplers, branches, reducers, socket plugs and flexible connectors for site drainage work.
TWS stocks a wider range of 200mm underground drainage products for trade and site use. This includes 200mm drainage pipe, couplers, slip couplers, bends, branches, reducers, end caps, socket plugs, pipe lubricant and flexible connectors.
View all 200mm underground drainage products at TWS.
Shop all underground drainage at TWS.
For general UK drainage guidance, see Approved Document H: Drainage and waste disposal.
