Description
The 160mm swept bend 90° single socket is an underground drainage fitting used to change the direction of 160mm pipework with a smoother bend profile. It is suitable for foul water and surface water drainage systems where a 160mm pipe run needs to turn through a right-angle direction.
This Funke underground drainage bend is designed for compatible 160mm PVC-U underground drainage pipework. The nominal 90° / 87° angle is used where a pipe run needs a larger change of direction within a planned drainage layout.
The single socket design provides one socketed connection, with the opposite end designed to connect into a compatible underground drainage socket or fitting. This makes it useful for new installations, pipework extensions, site drainage alterations and underground pipe repairs.
160mm Swept Bend for Underground Drainage
The 160mm swept bend is used where underground drainage pipework needs a right-angle change of direction. It is commonly used on larger domestic drainage systems, commercial groundwork projects and surface water drainage layouts where 160mm pipework is specified.
A swept bend profile helps create a smoother route around the change of direction compared with a tight bend. This can help keep the drainage layout neater and easier to maintain when suitable access is included elsewhere in the system.
- 160mm underground drainage swept bend
- 90° / 87° nominal bend angle
- Single socket design for compatible 160mm pipework
- Swept bend profile for a smoother change of direction
- Suitable for foul water and surface water drainage systems
- PVC-U underground drainage fitting
- Orange-brown / terracotta colour to match underground drainage systems
- Useful for larger domestic, commercial and groundwork drainage layouts
- Funke KGB 160mm single socket bend fitting
160mm Swept Bend Single Socket Connection
This 160mm swept bend has one socketed connection for compatible 160mm underground drainage pipework. The other end can be connected into a suitable 160mm socket, coupler or drainage fitting depending on the pipe layout.
Before installation, check the pipe route, fall direction and bend position. The bend should sit correctly in the trench and should not be forced into poor alignment. If the route does not line up correctly, adjust the pipework or use suitable additional fittings.
Use suitable pipe lubricant on ring seal joints where required. Also, make sure pipe ends are clean before jointing. If pipework is cut to length, make a clean square cut and chamfer the cut edge before fitting. This helps protect the seal and makes the joint easier to assemble.
160mm Swept Bend Installation Use
The 160mm swept bend should be installed as part of a properly planned underground drainage system. It is useful where a 160mm drainage run needs a right-angle change in direction while keeping the system neat and serviceable.
Correct bedding and backfill are important around the bend. The pipework and fitting should be evenly supported so the drainage system remains stable after installation. Poor support can place stress on the socket and may affect long-term performance.
Because this fitting changes the pipe direction, the wider drainage layout should include suitable access for future rodding, inspection or maintenance where required. Always follow the site specification, current UK drainage guidance and manufacturer instructions.
Drainage Bend for Site and Groundwork Use
This fitting is a practical product for builders, groundworkers, landscapers and drainage installers working with larger 160mm underground drainage systems. It can be used on new installations, pipework extensions, repairs and system alterations.
For best results, use compatible pipe and fittings from the same underground drainage system where possible. This helps keep jointing simple and supports a clean, consistent installation.
This product is not an access fitting. If inspection or rodding access is needed near this change of direction, use a suitable access bend, access pipe, inspection chamber or rodding point as required by the drainage layout.
Compatible 160mm Underground Drainage Products
TWS stocks a wider range of 160mm underground drainage products for trade and site use. This includes 160mm drainage pipe, couplers, slip couplers, bends, branches, access fittings, reducers, socket plugs, non-return valves, flexible connectors and testing accessories.
View all 160mm underground drainage products at TWS.
Shop underground drainage at TWS.
For official manufacturer range information, see the Funke HS® underground drainage pipe system.
