Description
The 160mm oval alloy rodding point is an underground drainage access fitting designed to provide a practical rodding and inspection point within a 160mm drainage system. It gives installers and maintenance teams a usable access point for clearing, inspecting and maintaining larger foul water and surface water drainage runs.
This rodding point is commonly used where 160mm underground drainage pipework needs a serviceable access point. The oval alloy cover gives a strong, hard-wearing finish, while the removable lid allows access when cleaning or rodding is required.
It is a useful fitting for builders, groundworkers, landscapers and drainage installers working on larger domestic, commercial and site drainage layouts. It can help keep the system easier to maintain after installation, especially where future access may be needed.
160mm Oval Alloy Rodding Point for Underground Drainage
The 160mm oval alloy rodding point is used to create an access point in 160mm underground drainage pipework. Access points are important because they allow the pipe system to be inspected and cleared without removing sections of pipework.
This type of fitting is often used where a drainage run needs a rodding point at a change of direction, near a connection, or in a location where maintenance access is required. Always position the fitting so the cover remains reachable after the drainage system is complete.
- 160mm oval alloy rodding point for underground drainage
- Provides access for rodding, inspection and cleaning
- Suitable for larger foul water and surface water drainage layouts
- Oval alloy cover for a hard-wearing finish
- Removable cover secured with screws
- Useful for trade, groundwork and drainage installation work
- Designed for use with compatible 160mm underground drainage systems
- Helps create a serviceable access point within the pipe run
160mm Oval Alloy Rodding Point for Maintenance Access
This 160mm oval alloy rodding point helps make a drainage system easier to maintain. If a blockage occurs, the removable cover gives access for rodding equipment, inspection or cleaning work.
Access fittings should be included at suitable points in the drainage layout. This helps reduce the need to disturb finished groundworks if the system needs attention later. It can also help contractors test and check drainage runs before completion.
The cover should remain accessible after installation. Avoid placing the rodding point where it will be permanently blocked by concrete, walls, landscaping, chambers or other fittings.
160mm Oval Alloy Point Installation Use
The 160mm oval alloy rodding point should be installed as part of a properly planned underground drainage system. Before fitting, check the pipe route, fall direction, access position and surrounding ground level.
Use the rodding point with compatible 160mm underground drainage pipework and fittings. Make sure pipe ends are clean before jointing. If pipe is cut to length, make a clean square cut and chamfer the cut edge before fitting. This helps protect seals and makes the joint easier to assemble.
Correct bedding and backfill are also important. The pipe and fitting should be supported evenly so the drainage run remains stable after installation. Poor support can place stress on joints and may affect long-term performance.
160mm Rodding Point for Site Drainage Work
This 160mm oval alloy rodding point is a practical product for site drainage installations, alterations and repairs. It is especially useful on larger pipe systems where future access is important.
Because underground drainage systems can be difficult to reach once backfilled, it is important to plan access points carefully. A rodding point can help make cleaning and maintenance quicker, cleaner and less disruptive later.
This product should not be treated as a chamber base. It is an access fitting for the drainage pipe run. If full chamber access is required, use a suitable inspection chamber or access chamber arrangement instead.
Compatible 160mm Drainage Products
TWS stocks a wider range of 160mm underground drainage products for trade and site use. This includes 160mm drainage pipe, couplers, slip couplers, bends, branches, access fittings, reducers, non-return valves, flexible connectors and testing accessories.
Use this rodding point with compatible 160mm underground drainage pipework from the same system where possible. This helps keep jointing simple and supports a cleaner installation.
View all 160mm underground drainage products at TWS.
Shop underground drainage at TWS.
For general UK drainage layout and access guidance, see the official GOV.UK Approved Document H drainage and waste disposal guidance.
